Full traceability
Every serialised part must be traceable to its material lots, inspections and deliveries.
aerospace quality management software
Quality management software for aerospace manufacturers
Aerospace work demands traceability of every part and material, rigorous nonconformance control and proof that people and gauges were qualified. QCIN keeps those records connected.
Aerospace quality challenges
Nonconforming product control
Suspect material must be identified, segregated and dispositioned with a record.
Qualified people and equipment
Auditors check that inspectors were trained and gauges calibrated on the day of work.
How QCIN supports aerospace teams
Serial & lot genealogy
Forward and backward trace up to 15 levels, including supplier lots and shipments.
NCR & disposition
Use-as-is, rework, repair, scrap and return-to-supplier decisions with cost and evidence.
Calibration
Gauge register with due dates and certificates; out-of-calibration gauges are blocked from use.
Training & competency
Skill matrix with training records and certificate expiry.
Document control
Versioned procedures and work instructions with approval and acknowledgment.
Supplier quality
CoA review, incoming inspection and supplier scorecards.
What QCIN does not do (yet)
- AS9102 first article inspection (FAI) forms are not built-in.
- Configuration management, ITAR/export-control features and customer-specific source inspection workflows are not included.
- QCIN is not certified by any aerospace standards body; AS9100 certification depends on your organisation's QMS.
Relevant QCIN modules
Frequently asked questions
Is QCIN AS9100 software?
QCIN supports processes AS9100 builds on — traceability, nonconformance control, calibration, competence, document control and audits — but it is not AS9100 certified and has no built-in AS9102 FAI forms.
Can QCIN trace serial numbers?
Yes, lots, batches, serials and materials are supported, and the genealogy shows which inspections, NCRs and complaints relate to each.
Can QCIN prevent use of uncalibrated equipment?
During inspections, measurement steps only accept gauges that are in calibration.
Where do we keep first article inspection records?
FAI forms are not a QCIN module; completed FAI reports can be stored and version-controlled in Document Control.
Run a aerospace quality pilot in QCIN.
Start a free 14-day trial — no card required — or book a walkthrough with our team.